204 Vehicle care
4. Insert bulb holder and turn
clockwise.
5. Insert left end of the lamp, slide to
the left and insert right end.
Centre high-mounted brake
light
Have LEDs replaced by a workshop.
Number plate light
1. Insert screwdriver in recess of the
cover, press to the side and
release spring.
2. Remove lamp downwards, taking
care not to pull on the cable.
3. Remove bulb holder from lamp
housing by turning anticlockwise.
4. Pull bulb from bulb holder and
replace it.
5. Insert bulb holder into lamp
housing and turn clockwise.
6. Insert lamp into bumper and let
engage.
Interior lights
Courtesy light, reading lights
Have bulbs replaced by a workshop.
Load compartment light
Have bulbs replaced by a workshop.
Dome light
Have bulbs replaced by a workshop.
Instrument panel
illumination
Have bulbs replaced by a workshop.
To Next Page
Loading...
