Eurocode Digi50 Controller V1.03 04/07/2005 Page - 15 -
Modes 7, 8, 9 and 0 are the same as the default value. (Mode 1)
(The printer will continue to print when under or over temperature)
(The printer will continue to print when under or over temperature)
(The printer will continue to print when under or over temperature)
Fault relay functions within the temperature range of the set point.
Printer operates with in the temperatures range of the set point.
Temperature Range. -10% to +10% of the set point.
Printer operates on all temperatures.
Fault relay functions within the temperature range of the set point.
Temperature Range. -10% to +10% of the set point.
Temperature Range. -5% to +5% of the set point.
Fault relay functions within the temperature range of the set point.
Printer operates within the temperatures range of the set point.
Temperature Range. -5% to +5% of the set point.
Fault relay functions within the temperature range of the set point.
Printer operates on all temperatures.
Printer operates within the temperatures range of the set point.
Temperature Range. -5% to +10% of the set point.
Fault relay functions within the temperature range of the set point.
Printer operates on all temperatures.
Temperature Range. -5% to +10% of the set point.
The Mode selector is a Rotary Switch located between the Front Panel and the Transformer.
Digi50 Mode Settings for Temperature Tolerance Ranges
Mode 4
Mode 6
Mode 5
SW4SW4
5
4
SW4
3
Mode 3
1
Mode 2
Mode 1 (Default)
6
SW4
2
SW4
SW4
Fault relay functions within the temperature range of the set point.
To Next Page
Loading...