CONTROL WIRE FOR A DOOR UNLOCK LIGHT
Please make sure the control wire (wire with the yellow sticker) is connected to an
“ACC/On” power source
; otherwise,when unlocking it with
AUX WIRING FOR A DOOR/DOME LIGHT
Please scan to see a detail instruction on Door Assist Sync or go to
https://wintis.ladesk.com/549690-AURA-Door-AssistAUX-Installation-Guide
NOTE : When remote unlock feedback is enabled, it will glow blue for 15 seconds.
METHOD : 1
STEP 1
door access system control harness that
connects between the door frame and
the door.
STEP 2
wire that activates the door lock/unlock.
HOW TO DIAGNOSE THE CORRECT
TRIGGER WIRE?
First, you must prepare a multimeter. Next,
please press the “Lock/Unlock" button on the
measurement process may take you a little
correct signal you need.
TRIGGER WIRETRIGGER WIRE
HARNESS
COVER
HARNESS
COVER
IMPORTANT
To Next Page
Loading...
