OPT7 Aura - Whats Included; Two Ways to Mount; Flat;Round Install with Rubber Mount; Boat Light Pod Fitment Steps

Decide where to locate the light
strips and ensure wiring has enough
length for control box to be installed
in desired location.
STEP 1
INSTALLATION
AUXILIARY WIRE EXTENSION WIRE
TM
TM
POWER SOURCE POWER HARNESS
TM
FUSE TAP
FUSE
BOX
GROUND
CIGARETTE POWER ADAPTER12 VOLT CHARGING PORT
Once connected, plug the control box Cigarette Power Adapter into an available
12 volt charging port.
As shown below, connect all light pods to the control box with the included
extension cables.
or, connect the positive wire to the fuse tap and connector the open negative wire to a
ground (any metal surface). Then plug the fuse tap into the 10amp switched fuse.