Do not attempt to service the projector unless you are qualied
and working under the direction of the manufacturer.
When using your projection equipment basic safety precautions should
be followed:
This equipment is for indoor use in moderate climates only.
All effect wheels should be stored in a dry, warm environment.
Always use the mains adaptor supplied suitable for your country.
Important Safety Instructions
Do not operate the appliance with a damaged cord, or if the
appliance has been dropped, or damaged, until it has been
examined by a qualied engineer.
Position the power supply so that it will not be tripped over, pulled
or come into contact with hot surfaces.
If an extension cord is necessary, a cord with a current rating at
least equal to that of the appliance should be used. Cords rated
for less amperage than the appliance may overheat.
Always unplug appliance from electrical outlet before cleaning
and servicing and when not in use.
To reduce the risk of electric shock – do not dismantle this
appliance.
Never use the equipment in damp or wet conditions. Avoid
excessive heat, humidity, dust and vibration.
Never pull cord to remove plug form outlet. Grasp plug and pull
to disconnect.
12
Designed and Manufactured in the UK by Optikinetics
Aura
To Next Page
Loading...
Need help?
General
