Equipment cart with cylinder holder
Installation and Operating Manual
OPTIKON 2000
6 INSTALLATION AND OPERATING PROCEDURE
6.1 INTRODUCTION
This section details a recommended installation and operational checkout
procedure for the Optikon Equipment Cart 183001. The operational checks,
however, which are performed after the system installation to verify instrument
operation, must be performed exactly as indicated and should not be regarded as
recommended practice or as encouragement for surgical operating room
procedures.
To bring your system in operation, a series of mechanical assembly operation for
the cart and a series of cable and tubing connections for the control console and
the accessories must be made.
Follow the installation and operating instructions carefully in a step by step manner
and, within a short time, you will have gained all the knowledge needed for
successful operation of your surgery system.
6.2 INITIAL INSPECTION
This instrument was carefully inspected, mechanically and electrically, prior to
shipment.
Before unpacking the OPTIKON Equipment Cart, inspect the carton for damage. If it
is damaged, be especially careful when inspecting the contents for any mechanical
damage which may have occurred during shipment, and test the electrical
performance.
If physical damage is found, you should apply at once to the carrier that handled
the consignment (mail, railways or forwarding agents) and have an appropriate
certificate established. Without documentary evidence, claim cannot be filed.
Cod. 183001EN 2010-03-09 Rev. D
6-1
To Next Page
Loading...
