Equipment cart with cylinder holder
Installation and Operating Manual
OPTIKON 2000
5 GENERAL INFORMATION
5.1 SYSTEM DESCRIPTION
The Optikon equipment trolley with cylinder holder 183001 has been designed to
host the Optikon surgical systems console and to move them conveniently in the
Operating Room area.
It is also provided with a housing for CO2 or N2O gas cylinders, and relevant
cylinder holders (spring).
The base of the cart is provided with antistatic wheels, with locking system.
5.2 CONTROLS AND INDICATORS
All controls and indicators are located on the rear of the cart.
1. POWER (ON/OFF MAINS SWITCH/PILOT LAMP)
This illuminated rocker switch controls the sockets to power the consoles
hosted by the cart. Provided that the mains switches of the single consoles are
left to the on position, this switch will energize or de-energize all the surgical
system.
2. MAINS POWER CONNECTION FOR HOSTED CONSOLES.
Three mains sockets allow connecting the mains power for the hosted surgical
consoles.
3. PROTECTION COVER
This transparent lid has been designed to prevent the use of the mains sockets
to connect any device other than an approved Optikon console. The lid must be
removed by a qualified technician when the console is first installed. The lid
must be restored in place once the equipment has been installed.
Cod. 183001EN 2010-03-09 Rev. D
5-1
To Next Page
Loading...
