Need help?Do you have a question about the OPTIKON ASSISTANT and is the answer not in the manual?
Manufacturer details, product model, and regulatory compliance.
Environmental operating conditions and electrical requirements.
Technical details for air, irrigation, and aspiration systems.
Available vacuum range, default and maximum flow rates.
Detailed specifications for the vitrectomy handpiece and operation.
Detailed specifications for the diathermy generator and handpieces.
Technical details for the illumination source and intensity.
Technical details for air and silicone injection systems.
Technical details for the phacoemulsifier handpiece and operation.
Available ultrasound modes and timer duration settings.
Classification based on IEC 60601-1 safety standards.
Physical dimensions and weight of the ASSISTANT equipment.
Graphs showing diathermy power versus load and preset.
Warnings regarding service, power connection, and general safety.
Precautions related to diathermy operation and potential hazards.
Safety guidelines for handpiece use, sterilization, and anaesthetics.
Guidelines for safe operation and environmental considerations.
Identification of components and controls on the front panel.
Identification of components on the left side of the unit.
Identification of components on the rear panel.
Details of connectors and the main power switch on the rear panel.
Overview of pneumatic system components within the unit.
Identification and location of key internal electronic boards.
Identification of components on the rear pump plate assembly.
Identification of components related to the Graphical User Interface.
Overview of the ASSISTANT system design and integrated functions.
Detailed explanation of the control board's logic and circuitry.
Explanation of the GUI and its interface with the Control Board.
Detailed explanation of the U/S driver board's functions and circuits.
Explanation of the diathermy driver section and its safety circuit.
Explanation of the sensors and air board's circuitry and functions.
Explanation of the vacuum signal filter board's function.
Explanation of the power board's role in generating DC voltages.
Procedures for checking output voltages and reference voltages.
Procedures for checking voltages and calibrating the U/S driver.
Procedures for touch screen recalibration and using calibration software.
Calibration steps for main and secondary pressure regulators.
Calibration steps for proportional valve, input pressure, vacuum, and air sensors.
Procedures for calibrating peristaltic pump flow and building Venturi pump table.
Tests for air/silicone tamponade, valves, and pump systems.
Tests for ultrasound, diathermy, illumination, and IV pole functions.
Procedures for testing the illumination module and performing optical alignment.
Procedure to verify the proper functioning of the thermostat.
Overview of all warning and error messages delivered by the console.
Detailed explanations and troubleshooting steps for specific error codes.
Diagnosis and resolution for errors occurring during the priming procedure.
Troubleshooting for other system errors, including battery issues.
List of essential electronic boards and key components as spare parts.
List of spare parts for pump, valve, and illumination modules.
List of spare parts for connectors, cables, and system accessories.
Procedure to enter calibration software and record the FLOW MAX value.
Steps for installing the programmer device software and connecting it.
Procedure for uploading software to the microprocessor.
Steps for installing the new software file onto the ASSISTANT unit.
Procedure for uploading the user interface software via PC.
Final calibration step involving the special calibration cassette.
General| Brand | OPTIKON |
|---|---|
| Model | ASSISTANT |
| Category | Medical Equipment |
| Language | English |
To Next Page
