Assistant Service Manual
OPTIKON 2000
Code 121008S 3-4 Rev. D
FLOW (CORRESPONDING TO THE PRESET INJECTION PRESSURE) BEFORE
INSERTING THE CANNULA IN THE EYE. FOR A BETTER FLOW CONTROL DO USE
1000 CS SILICONE OIL.
39) TO STOP SILICONE OIL INJECTION RELEASE THE INJECTION SWITCH. IN CASE OF
EMERGENCY CONDITIONS CLOSE THE INJECTION STOPCOCK OR DETACH THE
SILICONE INFUSION LINE FROM THE SILICONE DELIVERY DEVICE.
40) BEFORE USING A SURGICAL OR NON SURGICAL ACCESSORY IN CONNECTION
WITH ASSISTANT, VERIFY THE COMPATIBILITY OF THE SAME WITH ASSISTANT
EQUIPMENT. COMPATIBILITY IS STATED ON THE ACCESSORY ACCOMPANYING
DOCUMENT.
41) DISPOSE WASTE COLLECTION FLUIDS ACCORDING TO THE LOCAL
LAWS/REGULATIONS ON DISPOSAL OF ORGANIC MATERIALS.
42) WHEN AIR INJECTION IS ACTIVE, AN INTERMITTENT BEEP (0.9 SEC PERIOD) IS
GENERATED BY THE EQUIPMENT AS A WARNING SIGNAL.
43) SOUND EMISSION CAPABILITY OF THE EQUIPMENT IS TESTED AT POWER-ON.
VERIFY THAT AN AUDIBLE BEEP IS EMITTED DURING SYSTEM BOOT.
44) A ROTATING LOGO, PLACED AT THE LOWER SIDE OF THE USER INTERFACE
SCREEN, SHOWS THAT THE SYSTEM IS RUNNING PROPERLY. IF SUCH SYMBOL
STOPS MOVING IT MEANS THAT THE SYSTEM IS IDLE AND EQUIPMENT OPERATION
MUST BE STOPPED.
45) THE SILICONE INJECTION STOP VALVE IS TESTED AT POWER ON. VERIFY THAT NO
GAS LEAKAGE IS AUDIBLE DURING SYSTEM BOOT.
46) A VERY HIGH VOLTAGE (20KV) IS DELIVERED TO THE LAMP AT POWER ON FOR
IGNITION: DO NOT TOUCH INNER CABLE AND WIRING WHILE SWITCHING THE
LAMP ON. DO NOT POWER ON THE LIGHT IF THE ILLUMINATION MODULE WIRING
IS DISCONNECTED..
47) THE HID LAMPS OF THE ASSISTANT CONTAIN GAS AT A VERY HIGH PRESSURE.
THEY MAY EXPLODE CAUSING SERIOUS INJURIES TO THE EYES: WEAR
PROTECTIVE GOGGLES DURING BULB REPLACEMENT AND CALIBRATION. HANDLE
WITH EXTREME CARE. DO NOT TOUCH THE GLASS OF THE BULBS WITH FINGERS
AS STAINS AND GREASE MAY CAUSE LAMP EXPLOSION.
To Next Page
Loading...
