Assistant Service
Manual
OPTIKON 2000
Code 121008S
10-5 Rev. D
•
Close the Menu page.
•
Connect the telephone jack adapter to the programmer (align the
white line with the white arrow) and the jack into the socket as
shown in fig.11
Fig.11
•
Connect the USB connector from the programmer to your USB
port. Windows should recognize and install the new device
automatically. When you read "The new hardware is ready for use"
switch the Assistant ON.
10.3 STEP 3 - UPLOAD MICROPROCESSOR SOFTWARE
•
Double click the "PICkit 2 v2.11" on the desktop. Within a few
seconds a window should open with buttons to Read, Write, Erase,
Verify the microprocessor (fig.12)
To Next Page
Loading...
