Assistant Service Manual
OPTIKON 2000
Code 121008S 3-1 2009-07-24 Rev. C
3. WARNINGS
NOTE
: THIS INFORMATION IS BELIEVED TO BE CURRENT AT THE TIME OF
PUBLICATION, BUT IS PROVIDED WITHOUT WARRANTY OF ANY KIND AND
WE ASSUME NO RESPONSIBILITY WITH RESPECT THERETO.
1) SERVICE AND REPAIR OF THE SYSTEM SHOULD BE RESTRICTED QUALIFIED
TECHNICAL PERSONNEL AUTHORIZED BY OPTIKON 2000.
2) THE "OPTIKON OPTIKON ASSISTANT" CONTROL CONSOLE IS PROVIDED WITH A
VOLTAGE CHANGER. CHECK THAT THE CONSOLE IS SET TO THE PROPER
VOLTAGE BEFORE CONNECTING TO A MAINS SUPPLY. TO GUARANTEE SAFETY, A
HOSPITAL GRADE POWER CORD AND PLUG MUST BE USED, THE UNIT MUST BE
GROUNDED.
NOTE: SETTING A DIFFERENT INPUT VOLTAGE MAY REQUIRE REPLACING THE
MAINS FUSES. REFER TO THE TECHNICAL SPECIFICATIONS PARAGRAPH.
3) THE SYSTEM SHOULD NEVER BE USED IN THE PRESENCE OF FLAMMABLE
ANAESTHETICS, DISINFECTING AGENTS, CLEANING AGENTS, ETC., DUE TO
POSSIBLE FIRES OR EXPLOSION.
4) TO REDUCE THE RISK OF ELECTRIC SHOCK, UNPLUG THE EQUIPMENT FROM THE
MAINS BEFORE REMOVING COVER FOR SERVICING.
5) THE ASSISTANT CONTROL CONSOLE SHOULD BE CONNECTED TO A MAINS
SUPPLY ONLY AS MARKED ON THE REAR PANEL. TO GUARANTEE SAFETY, A
HOSPITAL GRADE POWER CORD AND PLUG MUST BE USED, THE UNIT MUST BE
GROUNDED.
6) FOR OPERATING SAFETY DO NOT INSTALL THE SYSTEM IN A LOCATION WHERE IT
WILL BE EXPOSED TO HEATING EQUIPMENT OR RADIATORS, DIRECT SUNLIGHT,
OR ANY OTHER SOURCE OF EXTREMELY HIGH TEMPERATURES.
7) DO NOT INSTALL THE ASSISTANT SYSTEM IN SUCH A WAY THAT THE VENTILATING
OPENINGS ARE BLOCKED.
8) BE SURE THAT THE POWER SWITCH ON THE CONTROL CONSOLE IS OFF WHEN
PLUGGING IN, OR REMOVING THE POWER CABLE FROM A WALL OUTLET.
9) TURN OFF THE MAIN POWER SWITCH WHENEVER THE ASSISTANT UNIT IS NOT IN
USE.
10) RISK OF BURNS OR FIRE; DO NOT USE DIATHERMY NEAR CONDUCTIVE
MATERIALS SUCH AS METAL BED PARTS, INNER-SPRING MATTRESSES, AND THE
LIKE. RENEW ELECTRODE CABLES UPON EVIDENCE OF DETERIORATION.
To Next Page
Loading...
