OPTIKON ASSISTANT - Table of Contents

TABLE OF CONTENTS
1. DISCLAIMER ........................................................................................ 1-1
2. TECHNICAL SPECIFICATIONS ........................................................... 2-1
2.1 DIATHERMY POWER CHARACTERISTICS .................................... 2-5
3. WARNINGS ........................................................................................... 3-1
4. GENERAL INFORMATION ................................................................... 4-1
4.1 EQUIPMENT LAYOUT ...................................................................... 4-1
4.1.1 FRONT VIEW (FIG.1) ............................................................................. 4-1
4.1.2 LEFT SIDE VIEW (FIG.2) ........................................................................ 4-3
4.1.3 REAR PANEL (FIGG. 3A & 3B) ............................................................... 4-4
5. INTERNAL VIEW .................................................................................. 5-1
6. PRINCIPLES OF OPERATION ............................................................. 6-1
6.1 INTRODUCTION ............................................................................... 6-1
6.2 CONTROL BOARD 393200 ............................................................... 6-5
6.3 GRAPHIC USER INTERFACE .......................................................... 6-6
6.3.1 U/S DRIVER 347888 ............................................................................. 6-14
6.3.2 SENSORS AND AIR BOARD 391120 ................................................... 6-23
6.3.3 VACUUM SIGNAL FILTER 369130 ....................................................... 6-28
6.3.4 THE ASSISTANT POWER BOARD 393130 ......................................... 6-30
7. CHECKS AND CALIBRATIONS ........................................................... 7-1
7.1 POWER SUPPLY BOARD 393130 ................................................... 7-1
7.2 CONTROL BOARD 393200 ............................................................... 7-1
7.3 U/S DRIVER 347888 ......................................................................... 7-2
7.4 THE SYSTEM CALIBRATION SOFTWARE ...................................... 7-3
7.5 SYSTEM TESTS AND CALIBRATIONS ............................................ 7-8
7.6 ILLUMINATION MODULE TEST AND CALIBRATION .................... 7-12
7.6.1 OPTICAL ALIGNMENT ......................................................................... 7-13
7.6.2 THERMOSTAT VERIFICATION ............................................................ 7-15
7.6.3 TOUCH SCREEN CALIBRATION ........................................................... 7-3
8. TROUBLESHOOTING .......................................................................... 8-1
8.1 WARNING AND ERROR MESSAGES .............................................. 8-1
9. AVAILABLE SPARE PARTS ................................................................ 9-1
10. SYSTEM UPGRADE AND CALIBRATION ......................................... 10-1
10.1 STEP 1 - REGISTER “FLOW MAX” VALUE ................................... 10-1
10.2 STEP 2 - INSTALL PROGRAMMER DEVICE ................................. 10-4
10.3 STEP 3 - UPLOAD MICROPROCESSOR SOFTWARE ................. 10-5
10.4 STEP 4 - INSTALL THE NEW SOFTWARE ................................... 10-8
10.5 STEP 5 - UPLOAD USER INTERFACE ......................................... 10-9
10.6 STEP 6 - CALIBRATION ............................................................... 10-13