Assistant Service
Manual
OPTIKON 2000
Code 121008S
7-10 Rev. D
a. Select Peristaltic mode, preset a vacuum of 300mmHg, panel.
Depress the footswitch beyond switch #2 and verify that the
vacuum rises gradually to the preset level. Vacuum rise time
depends on both the preset flow rate and rise time.
b.
Select Venturi mode, preset a vacuum of 300mmHg, panel.
Depress the footswitch beyond switch #2 and verify that the
vacuum rises to the preset level. Vacuum rise time depends on
rise time. Select Linear vac mode and verify that the vacuum
increases/decreases by depressing/releasing the footswitch
gradually.
8. ULTRASOUND Select U/S mode. Verify that:
•
With the handpiece unplugged, the message “Insert handpiece”
appears.
•
Plugging the handpiece, the message “Please prime” appears.
Do not install the ultrasonic tip on the handpiece, depress the
footswitch beyond switch #3 and verify that the message
“Please, check tip” appears.
Install the tip and depress the footswitch beyond switch #3 while
keeping the tip in water. Verify that the handpiece is tuned.
Select in turn “Continuous”, “Pulsed”, “Single Burst”, “Multi
Burst”, “Continuous Burst”, “linear Power”, “Panel”. For each
selection, depress the footswitch beyond position #3 and verify
that the ultrasound is emitted as expected.
9. DIATHERMY Select Diathermy mode. Connect the bipolar
microforceps from the unit to the Diathermy RMS meter, select a load
of 450ohm. Select the power level from 10% to 100% in steps of 10%.
At each level verify that the power emission activates when the
footswitch is depressed. At 100%, verify that the power emission is in
the range 5-7watt.
10. ILLUMINATION Verify that the appropriate light switches on/off by
depressing the Illumination button Light1 and Light2 in the GUI.
Switch ligth1 to ON, then select in turn tne green filter and light
intensities from 25 to 100. Verify that the diaphragm wheel works
correcltly.
Repeat the above test for light2.
11. ELECTRIC I.V. POLE Switch the equipment on. Verify that the
ASSISTANT tests the pole moving it slightly up and down. Once in the
To Next Page
Loading...
