Equipment cart with electric IV pole
Installation and Operating Manual
OPTIKON 2000
b. Assemble the equipment tray (5) at the desidered height using the
supplied screws and washers and Allen wrench.
c. Assemble the cylinder holder (6) in the suitable holes, according with
cylinder’s height.
d. Place the Optikon Console on the equipment tray.
e. Remove the protection cover covering the electric sockects (7) and
plug in the power cord for the equipment console. Re-install the
protection cover.
f. Plug the supplied mains power cord to the 183001 receptacle (8) and
into the wall mains outlet.
g. Switch on the equipment and the cart (9), then proceed according to
the hosted equipment user manual.
6.4 SHUT DOWN PROCEDURE
If the Optikon cart is not being used for an extended period, the following
procedure should be observed:
1. Depress the “Power” switch on the rear of the cart column to power down the
console and the cart.
2. Unplug power cord from wall outlet and roll it around the mushroom style
supports on the side of the column. Be sure to pull the plug, not the cord.
3. Place the system footswitch on the base of the cart, rolling the cable on the
supports at the side of the column.
4. Cover the hosted equipment and the cart with a drape to protect from dust.
Cod. 183001EN 2009-02-17 Rev. C
6-3
To Next Page
Loading...
