BIOLINE Manual for installation and use
OPTIKON 2000
• The standard AC-DC adaptor must be used exclusively to supply the instrument.
Ordinary maintenance
• Do not sterilise the probe in hot air or in a chemical autoclave.
• Do not use solvents or alcohol to clean the exterior of the instrument.
• The probe (and the relating packaging) is not supplied as sterile and must be
disinfected before it is applied to the cornea.
Precautions relating to the normal use of the instrument
• Gently apply the probe to the moist cornea, avoiding changing its normal
geometric arrangement.
• If you are in doubt about the accuracy of the measurement carry out a
calibration test on the probe and in the event of a negative result or incorrect
functioning, do not use the instrument and seek technical assistance.
• Thermal prints tend to deteriorate in time. For long-lasting storage it is advisable
to keep a photocopy of the print.
• Turn off the instrument at the switch when not in use
Code 141002EN 3-2 26.10.05 Rev.0
To Next Page
Loading...
