BIOLINE Manual for installation and use
OPTIKON 2000
9.3.2 ACCESSORIES
1) Avoid dropping or mishandling probes and accessories. It is critical that these
components be handled with outmost care and inspected thoroughly after each
use for any damage or wear.
2) Place the probes in the appropriate holder after each use. Avoid propping up the
probe on the table: if it falls over the point could be damaged, putting it out of use.
3) Place the protective caps on the probes when not in use for long periods.
Code 141002EN 9-2 26.10.05 Rev.0
To Next Page
Loading...
