OPTIKON BIOLINE - 11 Index

BIOLINE Manual for installation and use
OPTIKON 2000
11 INDEX
A
ACD ................................................................... 8-5
Anaesthetics ...................................................... 3-1
APHAKIC Parameter ......................................... 8-4
Arrow keys ......................................................... 7-2
A-SCAN Key ...................................................... 7-2
A-scan measuring session ................................. 8-1
Autotest Session ................................................ 8-1
B
Brightness Control ............................................. 7-3
C
CATAR Parameter ............................................. 8-4
Circuit Diagrams ................................................ 5-4
Clear Key ........................................................... 7-1
Connector for biometry probe ............................ 7-2
Constant A ......................................................... 8-5
D
D-BASE Key ...................................................... 7-2
Disposal of electrical and electronic equipment . 3-1
E
Electric shock..................................................... 4-2
Electrical warnings ............................................. 3-1
EYE Parameter .................................................. 8-3
F
Footswitch socket .............................................. 7-3
Fuses ................................................................. 3-1
G
GAIN .................................................................. 8-4
H
Holladay Formula............................................... 8-5
I
Internal lithium battery........................................ 8-6
IOL Calculation .................................................. 8-5
IOL Key.............................................................. 7-2
K
K1 ...................................................................... 8-5
K2 ...................................................................... 8-5
L
LCD Contrast ..................................................... 7-3
Liquid crystal display.......................................... 7-1
M
Main switch ........................................................ 7-3
Maintenance ...................................................... 4-2
MAN.GATE Mode .............................................. 8-4
Microprocessor .................................................. 5-4
O
On LED.............................................................. 7-2
Operating parameters ........................................ 8-3
Overheating ....................................................... 3-1
P
PC-LINK............................................................. 8-1
PHAKIC Parameter............................................ 8-4
Piezoelectric effect............................................. 5-4
POINT/ ENTER Key .......................................... 7-2
Precautions........................................................ 4-2
PRINTKey.......................................................... 7-2
Probe test .......................................................... 8-8
Protective probe caps ........................................ 9-2
PS.PHAK. Parameter ........................................ 8-4
R
Replacement of the printer paper....................... 9-3
RS232 Connector .............................................. 7-3
S
SET Key............................................................. 7-2
Solvents ............................................................. 3-2
Supply input ....................................................... 7-3
Symbols ............................................................. 4-2
T
Thermal print...................................................... 3-2
Thermal protection............................................. 3-1
Code 141002EN 11-1 26.10.05 Rev.0