Optimum B50 GSM - Default Chapter; Table of Contents

 2014
US
Seite 2 Geared drill B50 GSM Version 1.0.3 22 / 07 / 2014
OPTIMUM
MASCHINEN - GERMANY
Table of contents
Preface
C
h
a
n
g
e
s
The illustrations of the geared drill might in some details deviate from the illustrations of this operating manual but
this will have no influence on the operation of the geared drill.
Any changes in the construction, equipment and accessories are reserved for reasons of enhancement. Therefore,
no claims may be derived from the instructions and descriptions.
1Safety
1.1 Safety warnings (warning notes) ....................................................................................................... 6
1.1.1 Classification of hazards .................................................................................................... 6
1.1.2 Other pictograms ............................................................................................................... 7
1.2 Proper use ........................................................................................................................................ 8
1.3 Possible dangers caused by the geared drill .................................................................................... 8
1.4 Qualification of personnel ................................................................................................................. 9
1.4.1 Target group ...................................................................................................................... 9
1.4.2 Authorised personnel ......................................................................................................... 9
1.5 User positions ................................................................................................................................. 10
1.6 Safety measures during operation .................................................................................................. 10
1.7 Safety devices ................................................................................................................................. 10
1.7.1 EMERGENCY- STOP button ........................................................................................... 11
1.7.2 Main switch ...................................................................................................................... 11
1.7.3 Drilling table ..................................................................................................................... 12
1.7.4 Drill chuck guard .............................................................................................................. 12
1.7.5 Prohibitive, warning and information labels ..................................................................... 12
1.8 Safety check ................................................................................................................................... 12
1.9 Personnel protective equipment ..................................................................................................... 13
1.10 Safety during operation ................................................................................................................... 14
1.11 Safety during maintenance ............................................................................................................. 14
1.11.1 Disconnecting the geared drill and making it safe ........................................................... 14
1.11.2 Using lifting equipment .................................................................................................... 14
1.11.3 Mechanical maintenance work ........................................................................................ 15
1.12 Electrical system ............................................................................................................................. 15
2 Technical data
2.1 Power connection ........................................................................................................................... 16
2.2 Drill capacity .................................................................................................................................... 16
2.3 Spindle ............................................................................................................................................ 16
2.4 Drilling table .................................................................................................................................... 16
2.5 Work area ....................................................................................................................................... 16
2.6 Speeds ............................................................................................................................................ 16
2.7 Ambient conditions .......................................................................................................................... 17
2.8 Operating material .......................................................................................................................... 17
2.9 Coolant system ............................................................................................................................... 17
2.10 Emissions ........................................................................................................................................ 17
2.11 Dimensions ..................................................................................................................................... 18
3 Assembly
3.1 Delivery volume .............................................................................................................................. 19
3.2 Transport ......................................................................................................................................... 19
3.3 Storage ........................................................................................................................................... 20