Optimum Optidrill DM35 - Page 3

Version 1.0.5 dated 2019-06-05 Page 3Translation of the original instructions
DM35│DM35V│DM35PF│DM36VT│DM38VF│DM50│DM50V│DM50PM│DM60V│DM98V
GB
DM35xx_DM36VT_DM38VF_DM50xx_DM60V_DM98V_GB.fm
OPTIMUM
MASCHINEN - GERMANY
®
1 Safety
Glossary of symbols
This part of the operating instructions
 explains the meaning and use of the warning notes included in these operating instructions,
 defines the intended use of the magnetic drill,
 points out the dangers that might arise for you or others if these instructions are not
observed,
 informs you about how to avoid dangers.
In addition to these operation instructions, please observe
 the applicable laws and regulations,
 the statutory provisions for accident prevention,
 the prohibition, warning and mandatory signs as well as the warning notes on the magnetic
drill.
Always keep this documentation close to the magnetic drill.
INFORMATION
If you are unable to rectify an issue using these operating instructions, please contact us for
advice:
Optimum Maschinen Germany GmbH
Dr. Robert-Pfleger-Str. 26
D-96103 Hallstadt, Germany
Email: info@optimum-maschinen.de
Machine Variants
The variant for you machine is specified on the rating plate.
 OPTIdrill DM35
 OPTIdrill DM35V - with stepless speed.
 OPTIdrill DM35PF - with automatic feed.
 OPTIdrill DM36VT - with thread-cutting function and stepless speed.
 OPTIdrill DM38VF - with stepless speed in flat design. The flat design is suitable for hard to
reach drilling sites with low heights.
 OPTIdrill DM50
 OPTIdrill DM50V - with stepless speed.
 OPTIdrill DM50PM - with permanent magnet.
 OPTIdrill DM60V - with stepless speed.
 OPTIdrill DM98V - with stepless speed.

provides further instructions

calls on you to act

listings