Optimum OPTImill MH 50G - Default Chapter; Table of Contents

To Next Page

To Previous Page

OPTIMUM

MASCHINEN - GERMANY

Version 1.0.1 dated 2017-08-10Page 2 Translation of the original instructions

MH50G│MH50VGB

Table of contents

1 Safety

1.1 Type plates ...............................................................................................................................................6

1.2 Safety instructions (warning notes)...........................................................................................................7

1.2.1 Classification of hazards ...............................................................................................................7

1.2.2 Other pictograms...........................................................................................................................7

1.3 Intended use .............................................................................................................................................8

1.4 Reasonably foreseeable misuse...............................................................................................................9

1.4.1 Avoiding misuse ............................................................................................................................9

1.5 Possible dangers posed by the milling machine.....................................................................................10

1.6 Qualification ............................................................................................................................................11

1.6.1 Private Users...............................................................................................................................11

1.6.2 Obligations of the User................................................................................................................11

1.6.3 Craftsman or industrial use .........................................................................................................11

1.6.4 Authorized personnel ..................................................................................................................12

1.6.5 Operator's obligations..................................................................................................................12

1.6.6 Obligations of the operator ..........................................................................................................12

1.6.7 Additional requirements regarding qualification ..........................................................................13

1.7 User positions .........................................................................................................................................13

1.8 Safety measures during operation..........................................................................................................13

1.9 Safety devices ........................................................................................................................................13

1.9.1 Emergency stop button ...............................................................................................................14

1.9.2 Lockable master switch ...............................................................................................................14

1.9.3 Stored charge on MH50V............................................................................................................14

1.9.4 Separation guard.........................................................................................................................15

1.10 Safety check ...........................................................................................................................................15

1.11 Personal protective equipment ...............................................................................................................16

1.12 For your own safety during operation .....................................................................................................16

1.13 Switching-off and securing the milling machine......................................................................................16

1.13.1 Lockable main switch ..................................................................................................................16

1.14 Using lifting equipment ...........................................................................................................................17

1.15 Symbols on the milling machine .............................................................................................................17

1.16 Electronics ..............................................................................................................................................17

1.17 Inspection deadlines...............................................................................................................................17

2 Technical data

2.1 Electrical connection...............................................................................................................................18

2.2 Milling capacity .......................................................................................................................................18

2.3 Spindle seat............................................................................................................................................18

2.4 Drill-mill head..........................................................................................................................................19

2.5 Cross table..............................................................................................................................................19

2.6 Dimensions .............................................................................................................................................19

2.7 Work area ...............................................................................................................................................19

2.8 Speeds....................................................................................................................................................19

2.9 Environmental conditions........................................................................................................................19

2.10 Operating material ..................................................................................................................................20

2.11 Emissions ...............................................................................................................................................20

2.12 Tools and tool holding fixtures................................................................................................................21

3 Unpacking and connecting

3.1 Unpacking the machine ..........................................................................................................................22

3.2 Transport ................................................................................................................................................22

3.3 Installation and assembly .......................................................................................................................22

3.3.1 Installation site requirements.......................................................................................................22

3.3.2 Load suspension point ................................................................................................................23