OPERATING INSTRUCTIONS:
PRE-OPERATING INSTRUCTIONS:
• Carefully remove your fan from the box (please save the carton for off-season
storage).
• Make sure the unit is in the OFF position before plugging the unit into the outlet.
ASSEMBLY INSTRUCTIONS:
1. Take out the all fan parts from the packing
2. First of all, install the fan base and the standing pipe
** Install the standing pipe as following: Insert the part (16) into the standing pipe-down
(15), and then insert the part (17) into the standing pipe-down (15), as following picture:
**Install the standing pipe and the base together. And then lock the base in tightly by the
washer (20) and Base lock screw (21), as following picture: cture:
3.Install fan main body on the standing pipe steps:
STEP-1. REMOVE THE THUMB SCREW AND AXLE FROM
THE UPPER END OF THE STANDING PIPE.
STEP-2. REMOVE THE SCREWS FROM THE MOTOR
BRACKET
STEP-3. ATTACH THE MOTOR UNIT TO THE EXTENSION
POLE BY INSTALLING THE AXLE
STEP-4. REINSTALL THE SCREWS ON THE BOTH SIDES
OF THE MOTOR UNIT BRACKET
IMPORTMENT: Don't install the screws in wrong side
STEP-5. INSTALL AND TIGHTEN THE THUMB SCREW TO
HOLD THE MOTOR UNIT IN PLACE
To Next Page
Loading...
