16
If you want to record on a tape after
you have removed the erase-
protection tab for that side, place a
piece of strong plastic tape over that
side’s erase-protection hole. Be sure
you cover only the portion originally
covered by the erase-protection tab.
Note: Removing the erase-protection
tabs does not prevent a bulk eraser
from erasing a cassette tape.
CLEANING THE TAPE-
HANDLING PARTS
Dirt, dust or particles of the tape’s
coating can accumulate on the tape
heads and other parts that the tape
touches. This can greatly reduce the
performance of the cassette player.
Use the following cleaning procedure
after every 20 hours of tape player
operation.
1. Disconnect the power cord.
2. Open the cassette compartment
door.
3. Press
PLAY
to expose the tape-
handling parts.
4. Use a cotton swab dipped in
denatured alcohol or tape head
cleaning solution to clean the
record/play head, pinch roller,
capstan, tape guides, and erase
head.
5. When you finish cleaning, press
STOP/EJECT
and close the cas-
sette compartment door. Then
reconnect power.
Your local RadioShack store sells a
wide selection of tape head-cleaning
supplies.
13-1292.fm Page 16 Wednesday, July 14, 1999 6:37 PM
To Next Page
Loading...
