Optoma EX330 - Page 32

32
English
User Controls
Setup | Signal
Phase
“Phase” synchronizes the signal timing of the display with the
graphic card. If you experience an unstable or ickering image,
use this function to correct it.
Frequency
“Frequency” changes the display data frequency to match the
frequency of your computer’s graphic card. If you experience a
vertical ickering bar, use this function to make an adjustment.
H. Position

Press the to move the image left.

Press the to move the image right.
V. Position

Press the to move the image down.

Press the to move the image up.
“Signal” menu is
only supported in
Analog VGA (RGB)
signal.