Optoma ML300 - Page 4

Condential
ML300
III
Chapter 4 Function Test & Alignment Procedure
Test Equipment Needed 4-1
Test Condition 4-1
VGA Port Test 4-2
Composite Port And Audio Test 4-5Composite Port And Audio Test 4-5
HDMI 4-6
SD Card /USB ash disk/USB Test 4-6
Calibration 4-8
Waive Items 4-11
Run In Test 4-12
Test Inspection Procedure 4-13
Chapter 5 Firmware Upgrade
Section 1: System Firmware Upgrade 5-1
Equipment Needed 5-1
Check FW version 5-2
Section 2 : PIC Firmware Upgrade 5-3
Equipment Needed 5-3
PIC Firmware Upgrade 5-4
Section 3: MST7286 Firmware Upgrade 5-7
Equipment Needed 5-7
USB Driver Upgrade Procedure 5-8
MST7286 Firmware Upgrade Procedure 5-10MST7286 Firmware Upgrade Procedure 5-10
Section 4 : SSD1938 FW Upgrade 5-14
SSD1938 Firmware Upgrade Procedure 5-15