13
MISCELLANEOUS
Multipoint Connections
If you have stored pairing information for multiple devices and more
than one of those devices have Bluetooth enabled at the same time,
your BE6 will enable multipoint connection.
Multipoint connection allows your BE6 to hold connections with two
devices at the same time while playing audio signal from only one of the
two devices.
Multipoint connection works in the following ways:
• Your BE6 automatically connects with the most recently paired device
(“Primary device”).
• You must manually connect the second device (“Secondary device”) to
your BE6 via its operating system.
• The BE6 will prioritize the audio from Primary device.
• You can control Primary device using the BE6 in line controller.
• When Primary device is idle, your BE6 can receive audio from
Secondary device.
• Secondary device must be controlled directly from its operating
system.
• Simultaneous audio from both devices is disabled.
Restore Factory Settings
When you restore the BE6 to its factory settings, the paired devices
stored will be deleted.
To restore factory settings:
1 Ensure that your BE6 are not connected to any device.
2 Put the BE6 in pairing mode.
3 Press simultaneously the Power/Function, Volume Up, and Volume
Down buttons for 2 seconds until the LED indicator flashes red five times
and you hear five short tones from the BE6.
Because all pairing information is deleted after restoring factory settings,
the BE6 will directly enter pairing mode once powered on.
To Next Page
Loading...
