Installing and cleaning the dust lter
Installing the dust lter
Dust lters are only required/supplied in the selected regions with excessive dust.Note:
Cleaning the dust lter
We recommend you to clean the dust lter every three months. Clean it more often if the projector is used in a
dusty environment.
Procedure:
Switch off the power to the projector by pressing 1. the " " button on the remote control or the projector
keypad.
Disconnect the power cord.2.
Remove the dust lter carefully3. . 1
Clean or replace the dust lter4. . 2
To install the dust lter, reverse the previous steps.5.
To Next Page
Loading...
