optris PI - Page 36

optris PI – E2010-03-A
34
Ticking off the Show grippers/gripper labels enables you to change the position or the size of defined
measure areas by using the mouse.
Use the Name field to rename each measure area. Mode allows you to define the type of area (measure points
or rectangle).
Specify what temperature value - minimum, mean value or maximum - should be shown. Using Bind to
profile you can assign each measure area to specified temperature profile
In the Position section the exact position of the measure area within the camera image can be defined. If
desired the area can represent a hot spot (spot with highest temperature in the image) or a cold spot (spot
with lowest temperature in the image)
Measure are
a
assigned
to a temp
erature profile
(imeasure point )
Measure are
a
assigned
to a temp
erature
(reactangle)