optris PI - Configuration: Measure Areas

optris PI – E2010-03-A
33
Configuration: Measure areas
Available measure areas (modes)
Using New / Delete buttons you can create a new measure area (measure points/rectangle) or delete existing
measure area.
Press Up/Down to position individual measure areas within the list.
One measure area from the list can be appointed as the Main area (temperature of the main area converted
into electrical signal can be also transmitted via Process Interface (PIF)
By selecting Show in image measure areas can be displayed in the infrared image
Position (X, Y)
Measure points
(1x1)
Measure points
(3x3)
Measure points
(3x3)
Rectangle