Appendix C – Quick start for serial communication 111-
3. Select the baud rate that matches the baud rate of the other communication device. The other
interface parameters are 8 data bits, no parity and one stop bit (8N1).
These parameters are used in many other communication devices too. The other station must
support 8 bit data.
4. Connect the computer with the communication device. If this is a computer too, use a null modem
cable.
Command list
The command list is provided on the USB stick and in the PIX Connect software
(Help → SDK). Every command must expire with CR/LF (0x0D, 0x0A).
To Next Page
Loading...