Configuring Your System to Use Hardware Security Modules
Configuring Secure Sockets Layer Authentication 7-51
Error Messages Associated with Using Hardware Security Modules
The following errors are associated with using PKCS #11 hardware security
modules:
ORA-43000: PKCS11: library not found
Cause: The system cannot locate the PKCS #11 library at the location specified
when the wallet was created. This happens only when the library is moved after
the wallet is created.
Action: Copy the PKCS #11 library back to its original location (where it was
when the wallet was created).
ORA-43001: PKCS11: token not found
Cause: The smart card that was used to create the wallet is not present in the
hardware security module slot.
Action: Ensure that the smart card that was used when the wallet was created
is present in the hardware security module slot.
ORA-43002: PKCS11: passphrase is wrong
Cause: This can occur when
– An incorrect password is specified at wallet creation, or
– The PKCS #11 device password is changed after the wallet is created
and not updated in the wallet by using Oracle Wallet Manager.
Action: Depending on the cause, take one of the following actions:
– If you see this error during wallet creation, then check to ensure that
you have the correct password and re-enter it.
– If the password changed after wallet creation, then use Oracle Wallet
Manager to open the wallet and enter a new password.
See Also: "Creating a Wallet to Store Hardware Security Module
Credentials" on page 8-11
To Next Page
Loading...