Manual for Tire Pressure Monitoring Systems, TPMS
11/22
Standard Front/Rear Tire Pressure Setting
Tire Over Temperature Warning
After the setting operation of standard tire pressure, the
systems will automatically entry the setting mode of high tire
temperature.
The display unit will show tire over temperature warning
setup value (the factory default value is 80
o
C / 176°F.
) for the tires.
Pressing the set key for over 3 seconds can change to the
front tire standard pressure set up mode.
The wireless receiver and display unit will show the preset
front tire standard pressure default (34 psi / 230 kPa / 2.3
bar).
By pressing the function key once, the psi value will add 1
unit; and the unit value will return to 20 psi when it has
reached 48 psi. ( the kPa value will add 10 units; and the
unit value will return to 140 kPa when it has reached
330kPa / the bar value will add 0.1 units; and the unit value
will return to 1.4bar when it has reached 3.3 bar) The
system will use this setting as the standard value for low
tire pressure monitoring, which means when the tire has
deflated to a pressure value lower than this setting, the
system will automatically start to warn the driver.
As for the preset standard value 34psi/230kpa for tire
pressure monitoring. High tire pressure monitoring which
means when tire pressure has reached 51psi or 1.5 times
of the original standard value (the initial preset value is
345kPa or 3.5 bar).
For low tire pressure monitoring which means when tire
pressure has reached 27psi or 0.8 times of the original
standard value (the initial present value is 184 kPa or
1.8bar).
Press the set key to complete the front tire pressure
warning value setup mode. The system will automatically
enter the rear tire pressure set up mode.
Set up rear tire standard pressure value by using the same
steps 1~5 from front tire pressure warning value set up
mode.
To Next Page
Loading...