FRONT PANEL FEATURES
POWER: Switches on the mains power
to the amplifier. Refer to: ‘Important
Safety Instructions’ & ‘Before Using
Your Amplifier’. The jewel lamp will illuminate
when the power is switched on.
OUTPUT (15 WATTS/STBY/7 WATTS):
Make sure that the 15 WATTS/STBY/7
WATTS output switch is in the STBY
(middle) position before switching the power
switch to the ON position. The output switch
runs the valves at a low plate voltage (reducing
output power) in the 7 WATT position and at a higher plate voltage (increasing output power) in the
15 WATT position.
INPUT: Connect your instrument using good quality, shielded cable.
To Next Page
Loading...
