Operation Manual
CompactDual – Two in One
© 08/2019 Rev 0 / Subject to change without notice! Page 48/53
Percentage change of the welding parameters
This feature is very comfortable. It can be activated during the welding process via the shift
key on the remote control. Shift key must light up yellow (LED).
Possible adjustments are from 1-10%. This means that during the welding process you can
reduce and increase the current values by max. 50%.
Example:
You set 2%. Now, during the welding process, you can increase the high and base currents
by 2%, by pressing the I-button. (please make sure to have activated the shift key
beforehand). You can go up to 50%, pressing the I-button 25x along the perimeter of the
pipe.
In the welding circle you will see these changes displayed in black. Also any changes to the
cold wire are displayed here.
If necessary, all these adjustments can then be saved after the welding process. These data
will then be transferred once to the program.
To Next Page
Loading...