--37--
7.3 Troubleshoot
If any of the following issues occur, refer to the instruction manual and take the appropriate action.
Main clutch is not in work position.
High-Low range lever is in neutral.
Adjust the tension of belt.
Jammed foreign material in the track.
Too much amount of snow for one time.
Remove snow in several times.
Being caught in something
Remove obstacle or raise plow.
Plow Blade is set too low
Reduce the speed for operation.
Reduce the speed for operation.
Foreign object twined around tracks.
Too much amount of snow for one time.
Remove snow in several times.
Remove snow in several times.
Repair or replace transmission.
Co nt ro l le ve r wo n’ t mo ve s mo ot hl y
The lever is not in neutral position
The Hydraulic actuator is broken
Repair or replace transmission.
The pivot pin or cable is rusted
Starter w o n ’ t s t a rt
Clutch lever is not in PARKING position
Put the main clutch lever in Parking
Safety sensor is nor working
Check if it is pressed or replace it.
Harness came off or is damaged.
If you do not understand any of these points, please consult with the retailer where you purchased
this machine.
To Next Page
Loading...
Need help?
General