11
7. Easy Power Cord Storage:
a. Turn the cord wrap into the up position.
b. Wrap power cord around carry handle
and Helping Hand
®
handle.
Using the Light Duty Cleaning Wand
1. The Edge Series needs to be in the upright
parked position for the light duty cleaning
wand to engage.
2. Release the suction hose and crevice tool
from the hose clip.
3. If additional reach is needed, press the
release button on the side of the wand and
extend the orange tipped crevice tool.
Note: For heavier above the floor and
crevice cleaning use the Edge Series
handheld canister.
To Dock the Light Duty Cleaning Wand:
4. Make sure the tab on the wand holder is
facing out. Replace the hose in a downward
motion so the tab on the back of the wand
will fit into the slot on the bottom hose clip.
5. With flat end of the wand facing out. Snap
the top of the wand into the top hose clip.
3
2
a
1
b
4
5
To Next Page
Loading...
Need help?
General
