12
Cleaning
Tips
The new ORECK Upright is one of the finest, fastest, and strongest
units in its class.
You’ll love the way it cleans, gets under things, and it’s so light
weight and easy to use. The following are a few simple suggestions
regarding its operation:
NOTICE: Do not use your vacuum cleaner on damp or wet
surfaces. This will cause damage to the vacuum cleaner and is
dangerous to the user. Damage caused by use on wet or damp
surfaces is not covered under warranty.
1. When inserting a new disposable dust bag, first puff out
and OPEN the bag.
2. When the disposable dust bag is full, replace it.
3. Check the disposable filter dust bag at least once a month.
4. Do not run the vacuum cleaner over the cord. The revolving
brush could damage the cord.
5. Use caution when vacuuming over area rug edges and
fringe.
6. If at any time the machine does not pick up properly or
makes an unusual noise, stop operation and service.
7. Although your upright will pick up pins, paper clips, and
other small objects, it is recommended that these be
removed from the floor before you vacuum. Failure to do
so may result in permanent damage to the motor suction
fan and its housing.
8. At least once a month, check for and remove excessive lint,
string or hair from revolving brush. Wipe the outside of the
cleaner with a damp cloth. Also clean the connector
deflector assembly area, base of cleaner and fan housing
area. If there is dust in the outer bag, vacuum it or shake
it out.
NOTICE: Wood Floors, Soft (Vinyl, Asphalt Tile, etc.)
Floor Surfaces and Polished Floor Finishes.
Use floor and floor finish manufacturer’s recommended
methods of cleaning. The roller brush may also scuff very soft
finishes. Keep the unit moving while in operation. A little
preventative maintenance will keep your cleaner looking new
and will ensure continued cleaning effectiveness.
Bag dock
Outer bag zipper
Cardboard
collar
Replacing Disposable Odor Fighting Inner Bag
Unplug cord from electrical outlet before servicing.
Bag Removal
1. Unzip outer bag completely.
2. Pull bag cardboard collar to release bag dock door from
connector. Bag dock door will hinge downward.
3. Gently pull bag cardboard collar upward out of the bag
dock. Saniseal
®
dust seal will close automatically.
Bag Installation
1. Slide the cardboard collar completely onto bag dock door.
2. Firmly push bag dock door with both thumbs on indication
point until it snaps.