Oreck ProShield Plus User Manual

7
Cleaning the Pre-Filter
1. Unplug the air purier and lay it on its side with the hinged
cover on top.
2. Open the Top Cover by pressing the Cover Release button.
3. Pull the Pre-Filter straight up and out of the Cabinet.
4. Thoroughly rinse the Pre-Filter and let it air dry before
placing it back in the Cabinet. Do not use heated or com-
pressed air as part of the drying process.
5. Slide the Pre-Filter back into the unit.
6. Close the Top Cover securely.
The
air purier
will not run if the
Top Cover is not
closed securely.
2
1
3
5
Cleaning the Truman Cell
®
Note: The Truman Cell may require more frequent cleaning if
“arcing” occurs. Arcing is a sharp snapping sound that occurs
when large particles are collected in the Truman Cell
®
. If pro-
longed or continuous arcing occurs the Truman Cell
®
should be
cleaned.
1. Unplug the air purier and lay it on its side with the hinged
cover on top.
2. Open the Top Cover by pressing the Cover Release button.
3. Remove the Truman Cell
®
by pulling up on the handle
(located across the top), lifting it straight up and out.
4. Place in sink, bathtub or other location where cleaner can
cover every surface.

Oreck ProShield Plus Specifications

General

Brand	Oreck
Model	ProShield Plus
Category	Air Cleaner
Language	English