Oreck ProShield - Cleaning the Pre-Filter; Cleaning the Truman Collector Cell

7
Cleaning the Pre-Filter
1. Unplug the air purier and lay it on its side with the hinged
cover on top.
2. Open the Top Cover by pressing the Cover Release button.
3. Pull the Pre-Filter straight up and out of the Cabinet.
4. Thoroughly rinse the Pre-Filter and let it air dry before
placing it back in the Cabinet. Do not use heated or com-
pressed air as part of the drying process.
5. Slide the Pre-Filter back into the unit.
6. Close the Top Cover securely.
The
air purier
will not run if the
Top Cover is not
closed securely.
T
I
P
S
f
o
r
c
l
e
a
n
e
r
a
i
r
2
1
3
5
Cleaning the Truman Collector Cell
Note: The Truman Cell may require more frequent cleaning
if “arcing” occurs. Arcing is a sharp snapping sound that oc-
curs when large particles are collected in the Truman Cell. If
prolonged or continuous arcing occurs the Truman Cell should
be cleaned.
1.Unplug the air purier and lay it on its side with the hinged
cover on top.
2.Open the Top Cover by pressing the Cover Release button.
3. Remove the collector cell by pulling up on the handle
(located across the top of the Truman Cell). Lift the
collector cell straight up and out.
4.Place in sink, bathtub or other location where cleaner can
cover every surface.