Oreck ProShield - Dry Mode Operation

9
is completely dry, it will return to its original operating settings
and function as normal.
“Dry Mode” Operation
If the power supply detects that the Truman Cell is wet, it shuts
down power to the cell and causes the Collector Cell light to
blink rapidly.
1. While the collector cell light is blinking, press and hold the
power button to initiate “Dry Mode”
2. Next, the following will all happen simultaneously:
• Thecenterhalolightsegmentsaboveandbelowthe
powerbuttonwillash3times.
• Theunitwillswitchtomediumspeed.
• TheCollectorCelllightwillstarttoblinkinaslow
pattern.
4. Once in “DryMode”
• Theunitwillrunfor60minutesandthenattemptto
resetthepowersupplytotheTrumanCell.
• Ifthepowersupplysuccessfullyrestarts,theunitwill
returntoitsoriginalspeedandrunasnormal.
• Ifnotsuccessful,itwillgothroughthesameprocess
uptotwomoretimes.
• Ifstillnotsuccessfulafterthethirdtry,thecellislikely
damagedorisshortingoutduetothepresenceofa
foreignobject;itwillreturntotheoriginalspeedand
theCollectorCelllightwillblinkwitharapidblink
patternindenitelyuntiltheunitisreset.