3. The hour will now be flashing.
a. Press and release the "MIN/MAX" button
until the correct hour is shown.
Note: When in the 12h mode "PM" is
displayed under the word "TIME" during PM
hours. During the AM hours this area will be
blank.
b. When the correct hour is shown, press and
release the "SET" button once.
4. The minutes will now be flashing.
a. Press and release the "MIN/MAX" button
until the correct minutes are displayed.
Press and release the SET button once
more to complete the setup.
DETAILED SETUP GUIDE
I. BATTERY INSTALLATION
A. REMOTE TEMPERATURE SENSOR
1. Remove the mounting
bracket.
2. Remove the battery cover.
3. Observing the correct
polarity, install (2) AA
batteries—make sure they
do not spring free, or
start-up problems may
occur. Replace the cover.
5
To Next Page
Loading...
Need help?
General