6
GB
To check the moon phase for a particular day, press the UP/DOWN
button. The clock will enter moon phase scanning mode.
Use the UP/DOWN button to locate the date you want to check. The
calendar will be day-driven in this mode.
You can go back in time or travel to the future, the moon phase for
any day between the hundred years from 1990 to 2089 can be
accessed. The corresponding moon phase will appear immediately
on the screen.
The unit will return to the last display mode when the UP/DOWN
button is left idle for 15 seconds.
HOW TO WALL MOUNT OR USE
THE TABLE STAND
The unit can be wall-mounted using its recessed screw holes or
place on a flat surface using its table and control stand. To use the
stand, lay the control panel on a flat surface. Then adjust the angle
of the display panel for best display and support.
HOW TO RESET THE UNIT
The RESET slot allows you to return all settings to factory values.
Accessing the slot is required only when the unit is not operating
in a favorable way such as in the rare case of a malfunction.
The RESET slot is located inside the battery compartment door. To
use the button,
1. Lift open the battery compartment door.
2. Place a blunt stylus into the slot and press.
3. Replace the battery compartment door.
MAINTENANCE
When handled properly, this unit is engineered to give you years
of satisfactory service. Here are a few product care instructions:
Table stand
Wall-mount
1. Do not immerse the unit in water. If the unit comes in contact
with a water, dry it immediately with a soft lint-free cloth.
2. Do not clean the unit with abrasive or corrosive materials.
Abrasive cleaning agents may scratch the plastic parts and
corrode the electronic circuit.
3. Do not subject the unit to excessive: force, shock, dust, tem-
perature, or humidity. Such treatment may result in malfunc-
tion, a shorter electronic life span, damaged batteries, or dis-
torted parts.
4. Do not tamper with the unit’s internal components. Doing so
will terminate the unit’s warranty and may cause damage. The
unit contains no user-serviceable parts.
5. Only use new batteries as specified in this instruction manual.
Do not mix new and old batteries as the old batteries may leak.
6. Read this instruction manual thoroughly before operating the
unit.
TIME ZONE AND OFFSET TABLE
SPECIFICATIONS
• Temperature Measurement
Main unit
Indoor Temperature measurement
Displayed IN temperature range : -50.0°C t +70.0°C
(-58.0°F to 158.0°F)
Proposed operating range : -5.0°C to +50.0°C
(23.0°F to 122.0°F)
Temperature resolution : 0.1°C (0.2°F)
Remote Temperature measurement
Displayed OUT temperature range : -50.0°C to +70.0°C
(-58.0°F to 158.0°F)
Proposed operating range : -5.0°C to +50.0°C
(23.0°F to 122.0°F)
Temperature resolution : 0.1°C (0.2°F)
To Next Page
Loading...
