Oregon Scientific BAR122HGN - Troubleshooting Common Issues; Regulatory Compliance and Approvals

14
EN
EC-DECLARATION OF CONFORMITY
Hereby, Oregon Scientific, declares that this Digital Weather
Forecaster with Remote Thermo-hygro Sensor and Radio Controlled
Clock BAR122HGN is in compliance with the essential
requirements and other relevant provisions of Directive 1999/5/
EC.
A copy of the signed and dated Declaration of Conformity is available
on request via our Oregon Scientific Customer Service.
TROUBLESHOOTING GUIDE - BAR122HGN
Trouble Possible Cause Remedy
COUNTRIES RTTE APPROVAL COMPLIED
All EC countries, Switzerland CH
and Norway N
“---” is being displayed
for Remote data on the
display of the Main Unit
Displayed remote
temperature and/or
humidity data on the
display of the Main
Unit are different from
those on the display of
the Remote Sensor
(1) Probably due to
electromagnetic
interference and/or
obstacle in-between the
Main Unit and Remote
Sensor (e.g., double glass
protection or reinforced
concrete wall); or
(2) Batteries of the
Remote Sensor are being
discharged
Another Remote Sensor
using the same frequency
and same ID code is
being in use within the
effective area
(1) (i) Move the Main Unit
away from any source of
interference such as DECT
phone, mobile phone; and/or
(ii) Move the Remote sensor
nearer to the main unit and start
SEARCH mode in the Main
Unit
(2) Check LED of Remote
Sensor. Replace with new
batteries if it does not flash in
one minute
Place the Remote Sensor closer
to the Main Unit. Then reset
the Remote Sensor and activate
SEARCH mode in the Main
Unit