Oregon Scientific OUTBREAKER RA201 - Section 4: Sailing Timer Mode

15
GB
HOW TO SET THE SEA LEVEL PRESSURE
When you first use the RA201, please calibrate the sea level pressure.
Once the sea level pressure is calibrated, the altitude will
automatically calibrate to the reference altitude using the built-in
auto-calibration function.
1. Press and hold SET for two seconds in altitude-sea level pressure
display to enter the sea level pressure mode.
2. Press +/- to increase or decrease the values.
3. Press SET to confirm the setting and then quit the setting mode.
Refer to Fig 4f to set the sea level pressure.
Note:
• The current sea level pressure can be obtained from most of the
newspapers, local news and radio weather reports or through the
internet weather station.
• It is necessary to re-calibrate the sea level pressure and altitude
again once the product is placed in a pressurized cabinet such as
an airplane.
SECTION 4 SAILING TIMER MODE
INFORMATION SHOWN IN SAILING
TIMER MODE
Four information can be shown in sailing timer: local pressure, clock,
altitude and temperature. Press SELECT to access the information
one by one. Refer to Fig 5 to toggle between the information in
sailing timer mode.
SAILING TIMER
RA201 is equipped with three sailing timers: TIMER 1 –
chronometer with 99 laps memory; TIMER 2 – 10 minutes pre-set
timer; & TIMER 3 – 6 minutes pre-set timer.
No sea level pressure history No sea level pressure bar graph
Clock
Timer 2-10 min
sailing timer
Timer 3-6 min
sailing timer
Timer 1 -Chronometer
Altitude
Temperature
Local pressure
SELECT
SELECT
Fig.5
Fig.5a
SELECT
FUNC
FUNC
FUNC
FUNC
SELECT