16
GB
1. Press FUNC from any one of the display modes: sail-local
pressure, sail-clock, sail-altitude and sail-temperature to access
to the sailing timer.
2. Either TIMER 1 [
] or [ ], TIMER 2 [ ] and TIMER 3
[ ] can then be toggled to select by pressing FUNC. Refer to
Fig 5a to toggle between the three sailing timers.
Notes:
a) This chronometer works independently with the chronometer in
calendar clock mode.
b) This chronometer can run simultaneously with the chronometer
in calendar clock mode.
c) If the chronometer is used as a timer, after reset it will go back to
set time in the timer mode. The chronometer can be used as a
stopwatch only when the time shows 00:00:00
d) In the Sailing timer mode, only one of the timers, either TIMER
1, TIMER 2 or TIMER 3, can be run at a time.
e) Whenever re-entering the SAILING TIMER mode while the
watch in Sailing Timer mode is running it will automatically revert
to the last running timer.
TIMER 1 – Chronometer
Timer 1 can be used as a stopwatch with 99 laps memory function
as well as a countdown timer.
Use as a stopwatch:
1. Press ST/SP to start the stopwatch.
2. Press LAP to mark a lap memory.
3. Press ST/SP to stop the stopwatch.
4. Press and hold SET for two seconds to reset the stopwatch.
Use as a countdown timer:
1. Press and hold SET for two seconds to set the time for the
countdown timer.
2. Press SET to toggle between hour, minute and second setting.
3. Press +/- to increase or decrease the values.
4. Press SET to confirm the setting and toggle to next field.
5. Press ST/SP to start or stop the chronometer in clock-chronometer
display after setting.
6. Press and hold SET for two seconds to reset the timer.
Refer to Fig 5b for TIMER 1 operation.
Notes:
a) When countdown time reaches the last 5 minutes to last minute ,
short double beeping sound every minute.
b) At every 10 seconds during the last minute, there will be a short
double beeping sound.
Set hour Set minute Set second
Countdown timer
Stopwatch
Fig.5b
SETSET
SET
SET
SET
SET
+-
ST/SP
ST/SP
+-+-