Oregon Scientific RAR813 - Main Unit - Insert Batteries; Main Unit - Changeable Display

EN
5
To set up the sensor:
1. Open the battery compartment.
2. Insert the battery, matching the polarities.
3. Select a channel then press
RESET.
4. Return the battery compartment cover.
5. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
1.5 m (5 ft)
TIP
Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 1.5 m (5 ft) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
NOTE
• Press RESET after each battery change or
channel selection.
• Use alkaline batteries for longer usage and
consumer grade lithium batteries in temperatures
below freezing.
MAIN UNIT – INSERT BATTERIES
You need to install batteries before using the main unit.
1. Remove the battery compartment.
2. Insert the batteries, matching the polarities.
3. Press
RESET after each battery change.
4. Align the cover at against the battery
compartment, and then slide it upwards until it
clicks into place to lock the cover.
LOCATION
MEANING
Indoor temperature
display area
Main unit batteries low
Outdoor temperature
display area
Remote sensor(s)
batteries low
MAIN UNIT – CHANGEABLE DISPLAY
You can interchangeably adjust the indoor and
outdoor temperature display area by sweeping the
area on the main unit.
P/N:300103599-00001-10 REV1.0
Page:6/88