Oregon Scientific RAR813 - Sensor Data Transmission; Manually Set Clock; Temperature Display and Settings

6
EN
SENSOR DATA TRANSMISSION
To manually search outdoor sensor:
Press and hold MODE and at the same time.
The reception icon of the outdoor temperature shows
the status as follows,
ICON DESCRIPTION
Main unit is searching for
sensor(s).
A channel has been found.
The sensor cannot be found.
TIP
The transmission range may vary depending
on many factors. You may need to experiment with
various locations to get the best results.
MANUALLY SET CLOCK
To set the clock manually:
1. Press and hold MODE.
2. Press
or to change the settings. You can press
and hold these buttons to rapidly set the values.
3. Press
MODE to conrm.
4. The settings sequence is 12/24 hr format, hour,
minute, year (Y), calendar mode (day (D) – month
(M) / month (M) – day (D)), month, day and
weekday language.
NOTE
The language options are E (English), F
(French), D (German), I (Italy) and S (Spanish).
To select display mode:
Press MODE to choose between clock with seconds,
clock with weekday or calendar.
TEMPERATURE
To select the temperature display unit:
Press the °C / °F button to select the desired unit.
To toggle between each outdoor sensor’s readings:
Press CH repeatedly.
OR
Press and hold MEM and for 2 seconds to initiate
auto-toggling of outdoor channels.
OR
To end press .
To toggle between current, minimum and
maximum records:
Press MEM repeatedly.
To clear the records:
Press and hold MEM.
P/N:300103599-00001-10 REV1.0
Page:7/88