EN
3
3. RAIN ALERT : Toggle between rain alert / enable
alert / disable alert; enter rain alert setting mode
4. IN / MM : Select rainfall unit
REMOTE SENSOR (FIG. 3)
1. LED status indicator
2. Wall mount hole
3. Battery compartment
4. RESET hole
5. CHANNEL switch
GETTING STARTED
INSERT BATTERIES
1. Remove the battery compartment.
2. Insert the batteries, matching the polarities (see
FIG 2).
3. Press RESET after each battery change.
LOCATION MEANING
Clock area Main unit batteries low
Outdoor temperature Sensor batteries low
and humidity area
Rainfall area Rain collector sensor
batteries low
REMOTE SENSOR
To set up the sensor:
1. Open the battery compartment (see FIG 3).
2. Select Channel 1 then press RESET.
3. Close the battery door.
4. Place the sensor within 30 m (98 ft) of the main unit
using the table stand or wall mount.
TIP Ideal placements for the sensor would be in any
location on the exterior of the home at a height of not
more than 1.5 m (5 ft) and which can shield it from direct
sunlight or wet conditions for an accurate reading.
To Next Page
Loading...
