GB
12
MANUALLY SETTING THE CLOCK
The RMR-136HG is an ExactSet
TM
clock and does not need to
be set manually. However, instructions to set the clock manually
are included and follow:
1. Press and hold [MODE]. The hour digits of the time display
will begin to flash.
2. While the hour digits are flashing, press [ ] until the
desired hour is reached.
NOTE: When setting the hours, be aware of the AM/PM
designations.
3. When the hour is set, press [MODE] again and the minutes
segment of the time display will begin to flash. Repeat the
above steps to set the minutes, year, month, date and day-of-
the-week.
4. When the last setting has been made, press [MODE] to exit
the setting mode and return to the normal time display mode.
IMPORTANT: As soon as any manual setting changes are made
to the clock, the low signal strength icon will be displayed
indicating that the clock is now running on manual settings
instead of signals from the US Atomic Clock. In manual mode,
it is very unlikely that the RMR-136HG will receive signals
from the US Atomic Clock. To reactivate signal reception, press
[RESET] or remove the batteries, allow the unit to clear all
settings and then reinsert the batteries.
CUSTOMER ASSISTANCE
Should you have questions or require additional information
about this product, please contact our Customer Service
Department at 800-853-8883 or via email at:
www.helpme@oscientific.com
Please also visit our website at: www.oregonscientific.com
WARRANTY
Oregon Scientific warrants this product to be free of manufactur-
ing defects for 90 days from date of retail purchase. Defective
products should be returned to the place of retail purchase.
This warranty does not cover product subjected to tampering,
misuse, abuse or accidental damage.
PRECAUTIONS
This product has been designed and manufactured to provide you
with year of service if it is carefully handled. Please follow these
few precautions:
SELECTING THE DAY-OF-THE-WEEK
LANGUAGE DISPLAY
The RMR-136HG has three language choices for the day-of-the-
week display: English (E), Spanish (S) and French (F). To select
the display language:
1. Press [MODE] until the hour display begins to flash.
2. Press [MODE] five (5) more times and a single letter (E, S, or
F) will be displayed on the LCD screen next to the time
display.
3. Press [ ] to advance and sequence through the language
choices.
4. When the language is selected, press [MODE] one time to
exit the language setting mode and to return to normal time
display mode.
To Next Page
Loading...
Need help?
General
