7
GB
TEMPERATURE AND HUMIDITY
TREND INDICATOR ICONS
The temperature-trend and humidity-trend indicator arrow icons
show the trends based on collected readings.
NOTE: If the temperature exceeds or fall below the temperature
measuring range of the main unit or the remote sensor the main
unit LCD screen display will show “HHH” or “LLL”. See
“Specifications” for the temperature measuring ranges.
REMOTE SENSOR SCANNING
The main unit can be set to automatically scan and display data
readings from the remote sensor as well as indoor readings. When
the remote-sensor mode is active, the main unit LCD scree will
display the readings from one channel for approximately 4-
seconds and then proceed to display the next channel data.
To activate the remote-sensor scanning mode:
• Press and hold [CHANNEL] for 2-seconds.
To deactivate the remote-sensor scanning mode:
• Press any button.
MAXIMUM AND MINIMUM
TEMPERATURE AND HUMIDITY
The maximum and minimum recorded temperature and humidity
readings will automatically be stored in the memory.
To display the maximum and minimum display memory:
1. Press [CHANNEL] to select the channel to be checked.
2. Press [MEMORY] once to display the maximum (MAX)
temperature and then again to display the minimum (MIN)
temperature. The identifiers of “MAX” and “MIN” will be
displayed as appropriate.
To clear the memory:
• Press and hold [MEMORY] for 2-seconds.
After clearing the memory, the maximum and minimum
temperatures and humidity levels will be the same as current until
new data readings are recorded.
Humidity
Comfort-Level
Comfortable
Dry
Wet
Arrow
Indicator
Temperature
Trend
Rising Steady Falling
Arrow
Indicator
Humidity
Trend
Rising Steady Falling
To Next Page
Loading...
Need help?
General
