12
EN
If you wish to disable the auto-reception feature, press the [▼]
button for three seconds. The radio reception signal will disappear.
The unit will not respond to radio signals.
To enable the feature again, press the [▲] button for 3 seconds.
The radio reception signal will start blinking to initiate reception
automatically.
HOW TO SET THE CLOCK MANUALLY
To set the clock manually, hold [SET/MODE] for 3 seconds. The
display will return to MODE 1, with the hour digits blinking.
Use [▲] or [▼] to select the hour. Keep pressing the button will
increase or decrease the value rapidly.
Press [SET/MODE] to confirm. The minute digits will blink.
Repeat the same procedure to set the minutes, then the day-of-
month, month, display language, day-of-week and offset for the
second time zone.
Note that the time and date are displayed in 24-HOUR clock and
DAY-MONTH format, respectively. For display language, you can
choose among English (E), German (D), French (F) and Italian (I)
-in that order. Day-of-week is the usual sequence of Monday
through Sunday.
For the second time zone, which is indicated by the ZONE ICON,
enter the hour offset using the[▲] or [▼]buttons and the
RMR132HG will calculate the second time accordingly.
If there is an item you do not wish to change, simply press
[SET/MODE] to bypass the item.
When you are done, press [SET/MODE] to exit. The display will
return to the mode last chosen.
HOW TO SET AND ARM THE ALARMS
The RMR132HG has 2 alarms, ALARM 1 and ALARM 2. They
can be invoked together or independently.
To set an alarm,
1. Press [24 hr
OFF / ((•))] once to select ALARM 1 or again
to select ALARM 2. The last selected time of the alarm will be
displayed. If you have never set the alarm before, the time will
be displayed as 0:00.
2. Press [24 hr
OFF / ((•))] for 3 seconds. The hour digits will
blink.
3. Enter the hour using [▲] or [▼].
4. Press [24 hr
OFF / ((•))]. The minute digits will blink.
5. Enter the minutes using [▲] or [▼].
6. Press [24 hr
OFF / ((•))] to exit.
The alarm ON icon for the alarm chosen will be displayed indicating
the alarm set above is now armed.
You can also arm or disarm an alarm by pressing the
[AL ON/OFF] button.
RMR132HG_M_EN_R01 8/13/04, 12:30 PM12
To Next Page
Loading...
